Karnataka, India
Carbon Segmented Rings Manufacturer in Ballari
Carbon segmented rings for Ballari steel-plant turbines and blowers.

Carbon Segmented Rings Manufacturer in Ballari
The supplier steel-plant turbines and blowers use gland rings, and engineers want is a carbon segmented rings manufacturer in Ballari. Our segmented rings are lapped at each joint and supplied with garter springs, made to the groove and shaft you specify.
Carbon Segmented Rings in Ballari: Where They Run
Blast-furnace gas blowers and top-pressure recovery turbines at the steel complex use segmented gland rings.
Send groove and shaft sizes and gas pressure. If the turbine runs with water carry-over, tell us, since wet steam changes the grade we recommend. Shaft surface condition matters; a scored or grooved shaft sleeve will wear a segmented ring quickly and should be repaired or renewed. Check the groove sides as well as the bottom; a bell-mouthed groove lets the arcs tilt and leak.
Sending Your Requirement from Ballari
Send the sample or sketch from Ballari together with the operating details; dispatch also goes to Hosapete, Raichur and Anantapur. Related parts: Carbon Blocks and Carbon Radial Bearings.
Frequently Asked Questions
Blowers?
Yes; send the details and we will confirm the fit.
Send Your Requirement
Share the drawing or a sample, the operating medium, temperature, speed and quantity. Our engineers review it and reply with a grade recommendation and a quotation.




