Skip to Content

Engineering Capabilities

What we review and what we do for each enquiry, without claiming figures that depend on the part.

Request QuoteWhatsApp

Machined carbon graphite parts

What This Page Covers

This page says what we do and how we review an enquiry. It does not claim machine capacities, inspection equipment or tolerance values that depend on the part. Where a capability depends on size, material or shape, we confirm it against your drawing before quoting.

Published Grade Data

The ten Dmaic grades, DC-3105 to DC-3114, are listed on the grade chart with density, porosity, hardness, strength and heat limit.

Impregnation

Resin and metal impregnation routes are described on the impregnation page.

Machining Review

We machine carbon, graphite, silicon carbide, tungsten carbide and ceramic parts. For each enquiry we check the grade, wall thickness, bore and outside diameter, length, grooves, slots, segmentation, the counterface and the quantity, and tell you whether we can make it.

Tolerances

No one tolerance is a blanket capability. Carbon and graphite behave differently by grade, impregnation, shape and size. Show the critical dimensions and the acceptance criteria on the drawing, so we can confirm feasibility and the way to inspect before production starts.

Sealing Surfaces

Seal rings and mechanical seal faces are lapped. For sealing duty, give the mating material, face shape, flatness and finish needed, pressure and speed.

Repeat Orders

When a grade and a drawing have been approved, the same part can be made again in batches.

Send Your Requirement

Share the drawing or a sample, the operating medium, temperature, speed and quantity. Our engineers review it and reply with a grade recommendation and a quotation.